I'm running a Cable Plant with a ubr10012 CMTS with one ISp with DHCP, and the second was statix with policy in cablemodem config file. I will add a new ISP on my network in Dynamic addressing. How I can manage this ? if i authorize his cable modem, how I can tell him which dhcp pool to go ?
Maybe some Cisco software do that ? I dont know.
I'm using Cisco Network Registrar v5.5.10 for DHCP cable modem and Customer PC's.
When configuring the dhcp pools, it is important to include the command cable dhcp-giaddr policy in the cable interface configuration. This command has the effect of directing the DHCP server to assign leases to cable modems corresponding to the primary network number on the cable interface and leases to CPE corresponding to the secondary network number on the cable interface. If this command is missing then all DHCP leases will come from the pool corresponding to the primary network number on the cable interface.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...