I am in need of a single management software(console). To manage and display the topology of my LAN ..I have try Cisco network Assistant, which I have recently install but I only able to add cisco devices to communities
There are multiple network controller software modules (for example, MPLS, PNNI) that talk with the platform software via the VSI (Virtual Switch interface) protocol to deal with their respective network topology routing and signaling. Every connection added will take away from the edge concentrator's pool of limited resources (for example, total number of connections, bandwidth, or connection IDs). The resources that these controllers vie for include:
card-level resources-number of connections.
Port-level resources-connection identifiers (for example, DLCI, VPI, VCI, etc.) and bandwidth.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...