Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

measuring syslog traffic utilization

I have 3 RME servers connecting to 3 remote syslog servers running the RSAC software across 3 seperate wide area links.

How could I measure the traffic/utilization on those 3 links to try to figure what percentage of the total is used for syslog messages.

P.S. RME and Campus are the only CiscoWorks apps I have.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: measuring syslog traffic utilization

If you have a NAM or switch probe available you could use it to determine the amount of traffic sent on the specific port RSAC uses to forward messages to RME

3 REPLIES
Cisco Employee

Re: measuring syslog traffic utilization

If you have a NAM or switch probe available you could use it to determine the amount of traffic sent on the specific port RSAC uses to forward messages to RME

Community Member

Re: measuring syslog traffic utilization

As a matter of fact, the customer does have NAMs installed in their network!

Cisco Employee

Re: measuring syslog traffic utilization

If things are setup correctly you should be able to capture this traffic and see just how much it is generating.

142
Views
15
Helpful
3
Replies
CreatePlease to create content