You are looking for recommended thresholds and alarms on these objects. Unfortunately, there is no magic number that says what percentage utilization would be a good threshold to trigger an alarm. If a device has been running at 80% memory pool utilization for a while without a problem, there is no need to trigger alarms for the device. However, if a switch or router was using 10% of the memory pool in the past and the utilization suddenly shoots up to 70%, you will probably want to know about this.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...