Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Memory required for DFM 3.0

I was installing DFM 3.0 on a server and received an error message saying that there wasn't enough memory. 4096k was requested but I only had 4094k available. The installation went fine. Should I be worried about this? I have 526 devices. The server will only be used for DFM. RME and Campus are on another server. Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Memory required for DFM 3.0

No, you will be fine. This is just a rounding error. It sounds like you have the necessary 4 GB of physical RAM. Just make sure you have at least 8 GB of swap, and DFM will work just fine on this machine.

2 REPLIES
Cisco Employee

Re: Memory required for DFM 3.0

No, you will be fine. This is just a rounding error. It sounds like you have the necessary 4 GB of physical RAM. Just make sure you have at least 8 GB of swap, and DFM will work just fine on this machine.

New Member

Re: Memory required for DFM 3.0

Ok, thank you for help.

102
Views
0
Helpful
2
Replies