Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

message entry in syslog.log file of cisco works 2000 in window 2000 server

To start with single router was configured to log the enteries to cisco works 2000.Router was unable to make an entry in syslog.log of cisco works2000 on windows 2000 server but the router was able to log message on kiwi syslog daemon as well as on the router console.Please tell us, What should be done to make the router log messages to

syslog.log file of cisco works 2000 ?

4 REPLIES
Cisco Employee

Re: message entry in syslog.log file of cisco works 2000 in wind

Just make sure that the syslog service is started on the server and enable logging to the IP address of the server on the device.

logging

This should be all that is needed to make it to the server log file.

Try generating a message with packet capture enabled on the server to see if the message is making it to the server.

New Member

Re: message entry in syslog.log file of cisco works 2000 in wind

logging was enabled to the IP address of the server on the router. On another windows 98 machine kiwi syslog daemon was installed and

logging was enabled to the IP address of the

machine having kiwi installed.Now router was

supposed to log on both the machines (i.e. on

windows 98 machine having kiwi as well as on

the server having cisco works 2000).reload command was fired from the router the message

appeared on kiwi but there was not entry in

syslog.log file.

As per your suggetion packet capture software

is being down loaded and it will be viewed if message is making it to the server.

New Member

Re: message entry in syslog.log file of cisco works 2000 in wind

There is fire wall on our network.On an average four messages are being logged on to syslog server.Ciscoworks 2000 logs one message within two to four seconds where as kiwi(free syslog server) logs around all the messages generated by the fire wall.Most of the Messages from other devices are not logged on to syslog.log file by the ciscoworks 2000 .Are there any set up set changes / configuration changes required so that Cisco works 2000 logs all the messages in syslog.log file?

New Member

Re: message entry in syslog.log file of cisco works 2000 in wind

There is fire wall on our network.On an average four messages are being logged on to syslog server by the fire wall.Ciscoworks 2000 logs one message within two to four seconds where as kiwi(free syslog server) logs around all the messages generated by the fire wall.Most of the Messages from other devices are not logged on to syslog.log file by the ciscoworks 2000 .Are there any set up set changes / configuration changes required so that Cisco works 2000 logs all the messages in syslog.log file?

110
Views
5
Helpful
4
Replies
CreatePlease to create content