Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

message of HighUtilization from cisco LMS

Hi to all,

I'm getting this message from my cisco LMS

De: Lan_XXX [mailto:Lan_XXX]

Enviado el: Lunes, 05 de Enero de 2009 11:40 p.m.

Para: ZZZ, AAA [CUSC]

Asunto: 0008H06 ; 128.127.254.1 ; Mon 05-Jan-2009 23:39:39 CST ;

Critical ; Active

EVENT ID = 0008H06

ALERT ID = 00001L8

TIME = Mon 05-Jan-2009 23:39:39 CST

STATUS = Active

SEVERITY = Critical

MANAGED OBJECT = 128.127.254.1

MANAGED OBJECT TYPE = Switches and Hubs

EVENT DESCRIPTION =

HighUtilization::Component=PORT-128.127.254.1/95 [Gi6/32]

[EtherChannel-2];OutputPacketRate=5151.112

PPS;Type=ETHERNETCSMACD;CurrentUtilization=51.333706

%;InputPacketRate=43942.13 PPS;TrafficRate=6.4167132E7

BYPS;UtilizationThreshold=40;DuplexMode=FULLDUPLEX;MaxSpeed=1000000000;

CUSTOMER IDENTIFICATION = Switches

I believe i have to increase the UtilizationThreshold in order to stop the LMS sending this message but I can't find where to change it, I already checked the Device Fault Manager in the Configuration Polling and Thresholds -> Managing Thresholds tab but I can't find it.

Can you help me with this?

Thanks in advance

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: message of HighUtilization from cisco LMS

You can increase the threshold under DFM > Configuration > Polling and Thresholds > Managing Thresholds. When you're satisfied, go to DFM > Configuration > Polling and Thresholds > Apply Changes to active the new threshold. If you do not do this, then the threshold will not actually change.

You will need to increase the port utilization to at least 52% to prevent this event from being generated.

2 REPLIES
Cisco Employee

Re: message of HighUtilization from cisco LMS

You can increase the threshold under DFM > Configuration > Polling and Thresholds > Managing Thresholds. When you're satisfied, go to DFM > Configuration > Polling and Thresholds > Apply Changes to active the new threshold. If you do not do this, then the threshold will not actually change.

You will need to increase the port utilization to at least 52% to prevent this event from being generated.

New Member

Re: message of HighUtilization from cisco LMS

Hi JClarke,

I finally found it.

Thanks alot for your help.

168
Views
0
Helpful
2
Replies