Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MGX-8850 with AXSM-32-T1E1-E receiving SHM_CDF_INVALID_SW_ID

I have looked on line and in the forums here, so either I am not typing my search correctly or no one has posted this issue yet.

I am guessing I am not typing the information in correctly when I am doing the search.

this is what I am seeing.

MGX8850.7.PXM.s > dspcd 9

MGX8850                          System Rev: 05.05   Oct. 17, 2013 05:09:48 PST

MGX8850                                              Node Alarm: UNKNOWN

Slot Number:   9    Redundant Slot: NONE

                    Front Card          Upper Card          Lower Card

                    ----------          ----------          ----------

Inserted Card:      AXSM-32-T1E1-E      ---                 ---

Reserved Card:      UnReserved          UnReserved          UnReserved

State:              Failed              Empty               Empty

Serial Number:      SAG07269DN1         ---                 ---

Prim SW Rev:        ---                 ---                 ---

Sec SW Rev:         ---                 ---                 ---

Cur SW Rev:         4.0(12.200)         ---                 ---

Boot FW Rev:        4.0(12.200)         ---                 ---

800-level Rev:      B0                  ---                 ---

800-level Part#:    800-22229-01        ---                 ---

CLEI Code:          BA4A10SBAA          ---                 ---

Version ID (VID):   ---                 ---                 ---

Reset Reason:       On Power up

Card Alarm:         UNKNOWN

Failed Reason:      SHM_CDF_INVALID_SW_ID

Type <CR> to continue, Q<CR> to stop:

MGX8850                          System Rev: 05.05   Oct. 17, 2013 05:09:48 PST

MGX8850                                              Node Alarm: UNKNOWN

Miscellaneous Information:

Crossbar Slot Status:      EMPTY

Alarm Causes

------------

    UNKNOWN

Backcard Mismatch/Failed Reasons

---------------------------------

Upper Card

----------

    NO MISMATCH

Lower Card

----------

    NO MISMATCH

Type <CR> to continue, Q<CR> to stop:

MGX8850                          System Rev: 05.05   Oct. 17, 2013 05:09:48 PST

MGX8850                                              Node Alarm: UNKNOWN

Front Card Mismatch Reason

--------------------

NO MISMATCH

MGX8850.7.PXM.s >

Any help with resolving this would be much apriciated.

Thanks.

Everyone's tags (2)
292
Views
0
Helpful
0
Replies
CreatePlease login to create content