Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MIB for setting duplex state on IOS switch

Hello,

I am looking for a mib that will allow me to read/set the duplex setting of an interface.

To read the current operating status I can use ETHERLIKE-MIB::dot3StatsDuplexStatus

which is a ReadOnly status.

There are duplex references in MAU-MIB (DOT3-MAU-MIB.my) but the variables needed don't

seem to be supported by my image. Am I SOL?

I am running IOS 12.2(25)SG on a Catalyst 4507 switch. The image is

cat4500-ipbasek9-mz.122-25.SG.bin

Thanks in advance,

Barry

Go Oilers Go.

5 REPLIES
Cisco Employee

Re: MIB for setting duplex state on IOS switch

The DOT3-MAU-MIB is supported by this code, and it looks like configuration of the speed and duplex is supported provided auto-negotiate is disabled. However, I do not have a 4500 running 12.2(25)SG handy with which to test. What exactly are you trying to set, and what errors do you get?

Oh, and the Canes are most likely going to win ;-).

Cisco Employee

Re: MIB for setting duplex state on IOS switch

I have a 4507 in the lab, ran a few quick polls on some objects from this MIB and didn't see a problem.

Like jclarke mentions, which objects are you polling and what are your results?

New Member

Re: MIB for setting duplex state on IOS switch

I read DOT3-MAU-MIB many times and it never clicked that I could write to ifMauDefaultType. That was the ticket. Thanks for gently pushing me in the right direction.

The oilers are a lock for the cup after tonights win. :)

Barry.

Go Oilers Go!

Red

Re: MIB for setting duplex state on IOS switch

Only if Gretzky and Messier come back ;)

New Member

Re: MIB for setting duplex state on IOS switch

They were in the stadium... alas, a loss anyway :(

260
Views
19
Helpful
5
Replies
CreatePlease login to create content