We have customised monitoring software in our network and my duty is to send the SNMP traps and alerts in case of port shut down / device failure in one of my Cisco Cat 2960 Switch ( IOS : "flash:c2960-lanbasek9-mz.122-44.SE6/c2960-lanbasek9-mz.122-44.SE6.bin") . I have found out the MIB structures relevant to my Switch IOS in this link .
But I am exploring how to customised these MIBs structure in order to make it useful for my customised network monitoring system. Kindly help me how to customise the MIB structure base on the IOS that I have in my hand. Or any possible ways . Thanks for your support.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...