Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

mis-match txload/rxload

These 2 interfaces are point to point.

But why the tx and rx load does not match at all?

router#sh int s0/1.104

Serial0/1.104 is up, line protocol is up

  Hardware is PowerQUICC Serial

  Description: office

  Internet address is 72.19.25.241/30

  MTU 1500 bytes, BW 256 Kbit, DLY 20000 usec,

     reliability 255/255, txload 202/255, rxload 107/255

  Encapsulation FRAME-RELAY

  Last clearing of "show interface" counters never

router#72.19.25.242

Trying 72.19.25.242 ... Open

remote-gateway#sh int s0/0/0.104

Serial0/0/0.104 is up, line protocol is up

  Hardware is GT96K Serial

  Description: remote

  Internet address is 72.19.25.242/30

  MTU 1500 bytes, BW 1544 Kbit/sec, DLY 20000 usec,

     reliability 255/255, txload 17/255, rxload 33/255

  Encapsulation FRAME-RELAY

  CRC checking enabled

  Last clearing of "show interface" counters never

363
Views
0
Helpful
0
Replies
CreatePlease to create content