Any idea why i cant see detailed device view in DFM. Some devices are fine but some
devices detailed device view elements are not present.(under system and InterfaceStatus)
Also if device detailed device view is OK but trunk ports may not be managed state.(i thought that trunk ports are managed by default) I use snmpv3 and this is fresh install of LMS 2.6 with new updates.
I can do snmpwalk(v3) from device center E.g. to device which detailed device view is short.
It doesn't look like this device was properly managed. It could be that your SNMPv3 views are wrong. Check the config to make sure you're granting access for your v3 user to read the entire MIB tree. You might also try deleting the device from DFM, then re-adding it, and running a sniffer trace during the initial discovery to see if there are any SNMP errors.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...