Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Missing dot3Stat data from many devices??

We had an interesting problem. We are running 5 minute data collection on many devices and interfaces on both the ifTable and dot3StatTable. For several data collection intervals we continue to collect data from the ifTable, but had no data returned from the dot3StatTable!

Now, this was across many devices and interfaces. Is it possible that some networking event could cause the IOS agent to not report data for dot3Stat, such as a change to the spanning tree or something?

Not a lot more information on the devices (switch vs. router, for example), or IOS versions. These are all 10/100 Ethernet ports being monitored.


Cisco Employee

Re: Missing dot3Stat data from many devices??

Hi Brian.

The ifTable and dot3StatsTable report different things.




DESCRIPTION "A list of interface entries. The number of entries

is given by the value of ifNumber."

::= { iso(1) org(3) dod(6) internet(1) mgmt(2) mib-2(1) interfaces(2) 2 }



dot3StatsTable OBJECT-TYPE


DESCRIPTION "Statistics for a collection of ethernet-like

interfaces attached to a particular system.

There will be one row in this table for each

ethernet-like interface in the system."

::= { iso(1) org(3) dod(6) internet(1) mgmt(2) mib-2(1) transmission(10) dot3(7) 2 }

Do you think it's possible that for those devices that aren't reporting anything for dot3StatsTable, they don't have interfaces that meet the parimeters of that object?

Cisco Employee

Re: Missing dot3Stat data from many devices??

I assume from your description that most polling cycles DO return valid dot3StatsTable data from these same devices for these same ports, correct? If so, what do you mean when you say the data is missing for several intervals? Do you get zeros when you expect actual data, does the agent returns SNMP errors, or do you just get no response?

The exact list of objects being polled as well as the device type and IOS version for one affected device would be helpful.