We have Cisco 6509 (Hybrid OS) with NetFlow configured on it and we have configured the Cat OS with SUP2 for export of NetFlow data.
In the software, we are unable to see all the interfaces from the switch part, though they are UP and there is traffic flowing through them. The switch ports which do not show up are no different from the other ports. All the NetFlow enabled VLAN interfaces show up. Please find below the version of the SUP & MSFC:
WS-C6509 Software, Version NmpSW: 7.3(1)
IOS (tm) MSFC2 Software (C6MSFC2-PSV-M), Version 12.1(13)E12, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)
The SUP config is as below:
set mls nde <IP_Address> <Port>
set mls nde version 7
set mls agingtime long 64
set mls agingtime 32
set mls flow full
set mls bridged-flow-statistics enable 1-4,6-11,16-17,19,100,201-202,666,777
set mls nde enable
Any possible issues or reasons on why this is happening?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...