I am trying to figure out how to monitor total active calls. I have browsed through MIB and manually tried OID's with no luck. While browsing the MIB I can see different active call tables being populated, but I cannot monitor the table or figure out how. Please help. This is a c2851 with 12.3(14)T6.
The CISCO-POP-MGMT mib is most likely not supported on this hardware. The CISCO-POP-MGMT-MIB was designed/intended for dial platform such as AS5xxx. It will have some support for the 26xx/36xx platforms as these
I am trying to do the same thing where I want to find out the number of active calls going on my voice router, which has two T1 PRI's plugged into it.
I have looked everywhere on the internet and walked the MIB of the device and I cannot find the OID for the current active calls. The information above didnt seem to help me. Maybe I didnt under stand the output but I was hoping for a single OID that would return "xx" for active calls.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.