cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1746
Views
0
Helpful
1
Replies

Monitoring 3750 Stack with SNMP

Hi!

I would like to monitor the Stack Ports of a Catalyst 3750. In the SNMP Interface Table I see three interfaces for each Stack Port: StackPortX, StackSub-StX-1, StackSub-StX-2 (where X is the module number). Which of this interfaces should I monitor to get a DOWN alert when a connection between two ports fails?

Regards, LLS71

1 Reply 1

Joe Clarke
Cisco Employee
Cisco Employee

You should use objects from the CISCO-STACKWISE-MIB instead, as this will provide you a more accurate picture of your stack's status. There are also traps in this MIB that can alert you if the stack's health deteriorates.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: