Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Monitoring 3825 with MIB

I have to monitor a Cisco 3825 I'm using in order to interface PRI PBXs; 3825 is SIP controlled.

SW version: Cisco IOS Software, 3800 Software (C3825-IPVOICE_IVS-M), Version 12.4(21), RELEASE SOFTWARE (fc1)

I would like to know which are the MIBs i have to consider in order to get information and then monitor voice calls both per each E1 and the total amount (number of calls, rejected calls, total amount for erlang, lost calls, DSO busy/idle...) and also monitor the IP interface (uplink to IP network) from bandwidht point of view, pps,..

Thanks in advance

Simone

1 REPLY
Silver

Re: Monitoring 3825 with MIB

Below show the MIB objects that correspond to the output of these VoIP verification commands:

show voice port summary (for NM-2V card only)

show voice call summary

show dial-peer voice summary

show call active voice brief (for Cisco 3600 platform only)

show voice dsp (for NM-HDV card only)

242
Views
0
Helpful
1
Replies