Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Monitoring BGP using SNMP

Hi Friends,

We have BGP enabled on our networks with SNMP enabled to trigger alerts in case of link up/ downs. What we observe is when BGP session goes Active (but interface is up), we do not get any alert from SNMP saying BGP status has changed. The SNMP configuration is as below. Would appreciate if you can let me know if there is anything missing or something required to the config to monitor BGP state changes. Thanks in advance.

snmp-server enable traps snmp authentication linkdown linkup coldstart warmstart

snmp-server enable traps isdn call-information

snmp-server enable traps bgp

snmp-server enable traps config

snmp-server enable traps frame-relay multilink bundle-mismatch

snmp-server enable traps frame-relay

snmp-server enable traps frame-relay subif

snmp-server enable traps hsrp

snmp-server enable traps syslog

Best Regards,

Manoj

1 REPLY
Bronze

Re: Monitoring BGP using SNMP

Manoj,

Under your BGP config do you have "bgp log-neighbor-changes" enabled? This is how we get notifications on peering status changes. Hope this helps!

-Mike

http://cs-mars.blogspot.com

133
Views
0
Helpful
1
Replies
CreatePlease login to create content