Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

mrm - "Monitor source address is not configured"?!

Greetings,

I'm trying to use MRM, but the "manager" doesn't seem to know it's source address, despite looking like it does.

I've tried multiple source interfaces.

-----------------------------------------ip mrm manager TEST

manager Serial0/0.1 group 225.0.0.1

senders 1

receivers 2

-----------------------------------------

R3#sh ip mrm manager TEST

Manager:TEST/1.0.0.1 is not running

Beacon interval/holdtime/ttl:60/86400/32

Group:225.0.0.1, UDP port test-packet/status-report:16384/65535

Test senders:

5.5.5.5

Test receivers:

1.1.1.1

-----------------------------------------

R3#mrm TEST start

Monitor source address is not configured

-----------------------------------------

???!!!! Another interface (loopback)

-----------------------------------------

R3#sh ip mrm manager TEST

Manager:TEST/3.3.3.3 is not running

Beacon interval/holdtime/ttl:5/86400/32

Group:239.0.0.1, UDP port test-packet/status-report:50000/50001

Test senders:

5.5.5.5

Test receivers:

1.1.1.1

R3#mrm TEST start

Monitor source address is not configured

-----------------------------------------

I've tried this on various 3640s running enterprise 12.3, and a 2500 running 12.2(32). All have the same result.

1 REPLY
Community Member

Re: mrm - "Monitor source address is not configured"?!

Greetings,

It seems I missed the "sender-list 1" on the "receivers" line.

Regards,

Dave

87
Views
0
Helpful
1
Replies
CreatePlease to create content