MRTG queries OID's on the router. These OIDs are native to IOS and you do not need to configure anything (other than SNMP). If you are looking to monitor something out of the ordinary, post it and we'll see if we can help find the OID.
Thanks for your reply, but we do not want to give our client full access to SNMP RO.
We provide managed services but our client wants to monitor our service with MRTG (IP VPN service with Cisco routers). We want to configure restricted SNMP access for our client that provide only data for MRTG with no access to other statistics and SNMP data.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...