Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MRTG - Top n Only!

Hi, group.

Can I utilize MRTG to graph Top n only out of thousands of switch ports? thanks.

Leo

4 REPLIES

Re: MRTG - Top n Only!

You can graph vlans or ports of your choice, you just need to edit the mrtg.conf file and specify there what interfaces you want to monitor.

New Member

Re: MRTG - Top n Only!

I am ok and able to pull thousands of switch ports' utilization, but I do not require MRTG to present every single of them, I do hope somehow MRTG could just pick Top n dynamically to feed them into a .cfg file, thus, I would have a real-time snapshot of those Top n switch ports' utilization in our network, which i believe would be very useful. so, is it possible? Leo

Re: MRTG - Top n Only!

absolutly. You need to edit the cfg file I mentionned earlier.

New Member

Re: MRTG - Top n Only!

ok, figure it out by myself, it does take a while.

short answer, routers2.cgi http://www.steveshipway.org/software/

Leo

262
Views
0
Helpful
4
Replies