Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MSFC with more IP addresses is seen as multiple devices in RME

The customer has problem with MSFC in LMS 2.5.1. On the MSFC is a configuration where are interfaces for VLANs with IP addresses. This MSFC is seen as three standalone devices in DCR. In the device selector is this device three times (with different IP addresses). Is this the normal behavior of LMS?? How I prevent the adding of this device with multiple IP addresses as more devices? Thank you.

1 REPLY
Cisco Employee

Re: MSFC with more IP addresses is seen as multiple devices in R

This looks like bug CSCse38513 and is actually caused by DFM.

When the switch's Sc0 was discovered, it led to the discovery of the MSFC. DFM placed the switch's address, as well as MSFC's Loopback0 address, in the "Known" state.

This should be fixed as part of DFM 2.0.6

DFM 2.0.6 is part of the LMS 2.6 Updates package, which you can download

and install by logging in to Cisco.com and pointing your browser to:

http://www.cisco.com/kobayashi/sw-center/cw2000/lan-planner.shtml

104
Views
5
Helpful
1
Replies
CreatePlease login to create content