What is the current utilization for this port? Assuming an average packet size of 100 bytes (optimistically low), you're pulling 37,223,792 Mbps with a discard rate of just over 5%.
If you're experiencing problems with the data being collected in the NAM, then you might consider backing off the span data. If, however, the NAM's data looks okay, increase the discard threshold in DFM. A 10% threshold should prevent the alerts while still giving you a safe enough ceiling to spot potentially serious problems.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...