Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NAM module booting from maintenance image

Hi everybody,

I have a NAM in a 6509-E chassis with sup720, and every time I reset this module it boots with its maintenance image instead of with its application image. The only way I have meneged to boot the NAM with application image is with the command "hw-module module <slot> reset hdd:1". But, if I reset it without "hdd:1" argument (by default) or I reload it, the NAM boots again with maintnance image.

What can I do to set application image as the default image?

Thanks in advanced and best regards,

Luis

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: NAM module booting from maintenance image

Try hardcoding the hdd:1 into the config of the 6500:

boot device module hdd:1

Then see if the default reset command works.

1 REPLY
Cisco Employee

Re: NAM module booting from maintenance image

Try hardcoding the hdd:1 into the config of the 6500:

boot device module hdd:1

Then see if the default reset command works.

192
Views
0
Helpful
1
Replies