Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NAM Scheduled Caprture

Hi,

Is it possible to schedule a conversation capture between two hosts or VLAN? And how is it done.

thank you very much.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: NAM Scheduled Caprture

No, this is not possible. This was requested a long time ago in CSCed88137, but it has not yet been implemented.

4 REPLIES
Cisco Employee

Re: NAM Scheduled Caprture

You can trigger a capture by going to Capture > Buffers. You should see an Automatic_Capture buffer. Click on the "NAM Alarm" link to configure a capture alarm. Create a new Network Layer Conversation alarm for the variable you want (probably bytes). Configure the various alarm options (i.e. src and dst addresses), then set a rising threshold. This could be small if you want to see all the traffic. The check the radio button to start a capture.

New Member

Re: NAM Scheduled Caprture

Hi,

Thank you very much.

Is it possible to set specific time that the capture would be triggered, say 0100H and would last for 5mins?

thanks again..

Cisco Employee

Re: NAM Scheduled Caprture

No, this is not possible. This was requested a long time ago in CSCed88137, but it has not yet been implemented.

New Member

Re: NAM Scheduled Caprture

Thanks a lot, hopefully this could be implemented soon... This feature I think should be present on NAMs.

115
Views
0
Helpful
4
Replies