Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

NAM2 http Service

Hi,

I am having issues in http services of NAM2. I would appreciate if someone can share the experince for the same.

root@# ip http server enable

Enabling HTTP server...

/bin/rm: cannot remove `/usr/local/apache/logs/httpd.pid': Read-only file system

(30)Read-only file system: httpd: could not open error log file /usr/local/apache/logs/error_log.

Unable to open logs

ERROR: Failed to enable HTTP server.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: NAM2 http Service

I would first try removing and reinserting the NAM module.  If the problems persist, you will need to contact TAC or your reseller to get an RMA for this NAM.

4 REPLIES
Cisco Employee

Re: NAM2 http Service

This could indicate a bad NAM.  Post the show tech from the NAM.

Re: NAM2 http Service

hi,

I am unable to get show tech from NAM2, whenever i try to get show tech, moudule logged out.

root@ show ver

NAM application image version: 3.6(1a)

Maintenance image version: 2.1(3)

NAM Daughter Card Micro code version: 1.34.1.28 (NAM)

BIOS Version: 4.0-Rel 6.0.9

Installed patches:

Now i reloaded the module but it is not getting up and giving following error,

After rebooting the NAM its giving the below error, kindly look into it.

Feb  7 11:31:40.243 UAE: %C6KPWR-SP-4-DISABLED: power to module in slot 3 set off (Reset)
Feb  7 11:40:15.983 UAE: %C6KPWR-SP-4-DISABLED: power to module in slot 3 set off (Module  Failed SCP dnld)

Regards

Nadeem

Cisco Employee

Re: NAM2 http Service

I would first try removing and reinserting the NAM module.  If the problems persist, you will need to contact TAC or your reseller to get an RMA for this NAM.

Re: NAM2 http Service

Hi joe,

I just replaced the module and new module is working fine. The older module is gone faluty....even i tired to reload and re-inserted.

Thanks for the assistance!

Regards

Nad

520
Views
0
Helpful
4
Replies
CreatePlease to create content