Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

NAM2 v3.3 - old cumulative data appears

Hello

In NAM2 ver 3.3, after I delete data source

and unable to see current rates (due to data source absence),

I am still able to see all cumulative data for

data source already deleted.

Then I created new data source for totally different vlan,

and after that I see current rates for new data source,

but still able to see all old cumulative data from

data source already deleted.

Actually one data source is configured constantly to

monitor all the data.

Second data source is being used for monitoring of

particular vlans and this is the case that I have troubles with.

How can I get rid of old data and see the only new one

for current data source ?

Any suggestion would be highly appreciated.

Thanks,

Alex

4 REPLIES
Blue

Re: NAM2 v3.3 - old cumulative data appears

config clear will erase all data on the NAM

New Member

Re: NAM2 v3.3 - old cumulative data appears

config clear where ?

in NAM2' CLI ?

Alex

Blue

Re: NAM2 v3.3 - old cumulative data appears

Yes, from the CLI. Sorry for not being clear earlier

New Member

Re: NAM2 v3.3 - old cumulative data appears

Thank you

Will try

Alex

120
Views
0
Helpful
4
Replies