cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
728
Views
0
Helpful
2
Replies

NBAR is not accepted on a 6509 sub720?

MJonkers
Level 1
Level 1

When I try to enable NBAR on a vlan interface I get:

BAR 'protocol-discovery' command cannot be turned on this interface

because of the following reason:

Interface is a LAN port and NBAR/STILE is not supported on LAN

interfaces in PFC3.

When I try to activate it on a tengig interface the command does not exist.

Thx,

Marc

2 Replies 2

Joe Clarke
Cisco Employee
Cisco Employee

NBAR is not implemented in hardware for the Sup720. So if it was allowed to be enabled, it would severely cripple the switch. You should be able to enable it on FlexWAN interfaces, however.

If you look for NBAR in 65k switches you have to get the Sup 32 PISA:

http://www.cisco.com/en/US/partner/products/ps7209/index.html

This card is specifically designed for deep packet inspection (NBAR).

HTH

Mat

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco