I have one ncs appliance was working fine but after i reboot it i couldnt be able to access it through web. I can access it with cli and i saw some ncs service not running. The output of ncs status is attached with pic.
Thanks for all
TABUK-NCS/admin# show application status NCS
Health Monitor is running, with an error.
initHealthMonitor(): can not start DB
Ftp Server is running
Database server is stopped
Tftp Server is running
Matlab Server is Stopped
NMS Server is stopped.
CNS Gateway with port 11011 is down
CNS Gateway SSL with port 11012 is down
CNS Gateway with port 11013 is down
CNS Gateway SSL with port 11014 is down
Plug and Play Gateway Broker with port 61617 is down
Plug and Play Gateway config, image and resource are down on https
Plug and Play Gateway config, image and resource are down on http
Plug and Play Gateway is stopped.
SAM Daemon is not running ...
DA Daemon is not running ...
Syslog Daemon is not running ...
Is it working?
- If the problem, persists, then it seems that your Prime installation got corrupt -> re-install cisco-prime and restore data from a recent application backup.
- You could try that, but you will be re-initializing the database only -> meaning issue at least an ncs stop followed by ncs start ,and last but not least , ncs status, afterwards; if problems are still not resolved , you will need a complete re-installation of your Prime-host.
I don't know what version of ncs you're working with, but I'd just start over from the beginning with the install guide and like someone else said, restore from backup once you're reinstalled.