NCS Patch to use when moving from Prime 18.104.22.168 to 1.3
In the Software Release notes for Prime 1.3 (from 22.214.171.124), the need to apply a patch during upgrades is indicated. The type of patch needed depends on how the 126.96.36.199 was installed.
Prime Infrastructure 188.8.131.52 and 184.108.40.206 Patch
This patch MUST be applied on top of your existing Prime Infrastructure 220.127.116.11 (migrated from 18.104.22.168), before upgrading or restoring to Prime Infrastructure 22.214.171.124. This patch addresses critical defects in backup and restore.
Prime Infrastructure 126.96.36.199
This patch MUST be applied over top of your existing Prime Infrastructure 188.8.131.52 before upgrading or restoring to Prime Infrastructure 184.108.40.206. This patch addresses critical defects in backup and restore.
There is no internal knowledge on how the Prime 220.127.116.11 was arrived at (either through upgrade or otherwise).
How can I tell what previous patches have been installed?
How can I definitelly know which patch I need to install?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...