I have Cisco switches reporting to NCS, I see mac addresses but no ip addresses. I do not see any where to add a core router or arp table polling. Has anybody got ip addresses to report on the wired side?
NCS' management of wired infrastructure is very limited. The best wired management option is still LMS.
You can upgrade your NCS to Prime Infrastructure 1.2 and get some additional wired management functionality (including the ability to manage your routers and thus, I believe, get the IP address correlation with the MAC addresses) but it still lags LMS's capabilities bit.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...