I am running Ciscoworks LMS 2.6. I was trying to create a custom report that shows the sup cards, line cards, fan models and power supply models in our switches. I can't seem to find the attributes for the fan and power supply. I also ran the detailed device report and it's not pulling fan information from the switches. Is this normal? Any advice is appreciated. Thanks!
Getting fan information in a custom report is not possible in RME 4.0. I started a campaign to get all of the inventory attributes available for custom reports, but they finally all made it into RME 4.2.
As for not seeing fan information in the DDR, it depends on the switch type. For what switches are you seeing this?
Most devices are 6509s running CATOS, version 8.6(3). There are some 6509s that are running IOS version 12.2(18)SXF14 and also a couple 6513s running IOS version 12.2(18)SXF10. None of these are pulling fan information. The only field that is populated is the Index field with a 0.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...