Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

need help to configure a PIX 501

hello everybody,

i need some help to configure my firewall pix 501. I have some probleme with the outside interface. With the PDM (System property/interface) i see that my outside interface is enable. But on the monitoring there is a red cross near the outside interface.

with telnet when i do "show interface" i can see this result:

interface ethernet0 "outside" is up, line protocol is down

i try to put the line protocol on UP but i find no way!!!

more over when i connect a PC on the outside interface (with the good IP, 192.168.4.2 for the PC and 192.168.4.1 for the outside interface) there is no answer with a simple ping!!!

1 REPLY
Silver

Re: need help to configure a PIX 501

Based on your problem in configuring a Pix 501firewall device, I think the following document will provide u in-depth information about pix 501 firewall security appliances.http://www.Cisco.com/en/US/products/hw/vpndevc/ps2030/tsd_products_support_series_home.html.

And the below link will provide u with all the troubleshooting details.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/prod_tech_notes_list.h

100
Views
0
Helpful
1
Replies
CreatePlease to create content