We have the current configuration for our snmp and wanted to change it to SNMPv3. What would be the config for the SNMPv3 version? We use an access list to currently only allow snmp traffic to certain management stations. The access list number is 5. We also do not want any snmp traps sent. We use the logging feature for that.
no snmp traps
snmp-server community SCH_xxx RW 5
snmp-server community SCH_xxx RO 5
What would this config look like in snmpv3? Thank you!
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...