Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Need some Help CISCO 6504 SNMP???

Hi,

We use a CISCO 6504 with a single SUP 32. Is there any specific SNMP trap and OID if the SUP 32 goes down or fails??? Also i need one for the system reboot.

Thanks!!!

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Need some Help CISCO 6504 SNMP???

For a module going down, the switch will send a moduleDown trap from the CISCO-STACK-MIB.  This can be enabled with the "snmp-server enable traps module" command.  For a reboot, there is the warmStart and coldStart traps.  These are enabled with the commands "snmp-server enable traps snmp warmstart" and "snmp-server enable traps snmp coldstart" respectively.

1 REPLY
Cisco Employee

Re: Need some Help CISCO 6504 SNMP???

For a module going down, the switch will send a moduleDown trap from the CISCO-STACK-MIB.  This can be enabled with the "snmp-server enable traps module" command.  For a reboot, there is the warmStart and coldStart traps.  These are enabled with the commands "snmp-server enable traps snmp warmstart" and "snmp-server enable traps snmp coldstart" respectively.

374
Views
0
Helpful
1
Replies
CreatePlease to create content