Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

net config question

I am planning to replacing the access list from the interface, I am wondering how I can do that on netconfig. here is the example

current Interface

FastEthernet0/0.300

description *** Local Network ***

encapsulation dot1Q 200

ip address 10.32.180.25 255.255.254.0

ip access-group production_in in       

ip access-group production_out out

and want to replace to

FastEthernet0/0.300

description *** Local Network ***

encapsulation dot1Q 200

ip address 10.32.180.25 255.255.254.0

ip access-group lab_in in       

ip access-group lab_out out

is this achived by netconfig job or compliance management. I am really apperciate if some one give me straight forward direction. Thanks much

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: net config question

Netconfig might be quickest.  Just create a new adhoc job to do:

no ip access-group production_in in

no ip access-group production_out out

ip access-group lab_in in

ip access-group lab_out out

1 REPLY
Cisco Employee

Re: net config question

Netconfig might be quickest.  Just create a new adhoc job to do:

no ip access-group production_in in

no ip access-group production_out out

ip access-group lab_in in

ip access-group lab_out out

163
Views
0
Helpful
1
Replies
CreatePlease to create content