I think your mean RME 3.5 as Netconfig is component of Resource Manager Essentials and not Campus Manager. In any event, Netconfig 3.x requires an interactive session, so valid telnet or SSH credentials are required for Netconfig to work.
The error indicates that you do not have the correct password entered in RME for this device. Set your attributes for this device under RME > Administration > Inventory > Change Device Attributes. Once the attributes are correct (i.e. telnet passwords and enable passwords) the Netconfig job should complete.
If you still get the same problem, you should collect a sniffer trace of the job, then open a TAC Service Request, include that sniffer trace and a show ver/show run from the device in question.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.