I want to deploy some tacacs+ commands unto several switches and i tried this using netconfig and because of the peculiar commands for my deployement, i had to create a new task and deploy it on all switches.
but i got thsi error from netconfig.
*** Device Details for XXXXXXXXXXXXXXX ***
Message: ERROR:RME_CDL1021:No command generated. There are no commands to deploy.
The commands you have selected may not be applicable for this device, or this device may not be supported. You need to provide more details as to exactly what device this is, and what commands you are deploying, and how you set up your custom template.
If this information is too sensitive for you to share on a public forum, consider opening a TAC Service Request, and provide the data there.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...