Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our beta test area to get started.

New Member

Netconfig issue : Impossible to select devices when creating a job

Hello all,

I am trying to create a netconfig job but i have an issue: I am not able to select devices in the device selector left window. I am seeing all my devices but the box i have to click to select the device appears in light grey and it's not clickable.

Of course when i click on next, LMS says that it's not possible to go further because i didn't select any device. ("CFG0006: No devices selected. Select one or more devices to continue.")

Do you have any idea where the pb is coming from ?

Best Regards,

Adrien

PS: For information, i am running RME 4.2

  • Network Management
2 ACCEPTED SOLUTIONS

Accepted Solutions
Cisco Employee

Re: Netconfig issue : Impossible to select devices when creating

You have a package problem. This may be solved by shutting down Daemon Manager copying all of the .zip files from NMSROOT/www/classpath/com/cisco/nm/xms/psu/pkgs/rme to NMSROOT/MDC/tomcat/webapps/rme/WEB-INF/lib/pkgs.

If that does not work, you will need to open a TAC service request analyze the problem further.

Cisco Employee

Re: Netconfig issue : Impossible to select devices when creating

Assuming nothing else changed, this is most likely a timing issue. After restarting Daemon Manager, you should give the daemons about 30 minutes to fully initialize and settle before trying to access LMS.

4 REPLIES
Cisco Employee

Re: Netconfig issue : Impossible to select devices when creating

You have a package problem. This may be solved by shutting down Daemon Manager copying all of the .zip files from NMSROOT/www/classpath/com/cisco/nm/xms/psu/pkgs/rme to NMSROOT/MDC/tomcat/webapps/rme/WEB-INF/lib/pkgs.

If that does not work, you will need to open a TAC service request analyze the problem further.

New Member

Re: Netconfig issue : Impossible to select devices when creating

Hello,

Thanks for your reply ! I tried what you advised, and i have now a new error when i am accessing netconfig:

CFG0008: Error occured while processing.

Possible Cause: URN_NOT_FOUND : urn "JRM" : Not found !!

Now the two Netconfig windows (device selector and task selector) are blank.

Any idea ? If not, i will try to open a TAC service request.

Best Regards,

Adrien

Cisco Employee

Re: Netconfig issue : Impossible to select devices when creating

Assuming nothing else changed, this is most likely a timing issue. After restarting Daemon Manager, you should give the daemons about 30 minutes to fully initialize and settle before trying to access LMS.

New Member

Re: Netconfig issue : Impossible to select devices when creating

Hello,

You were right, i tried too early after restarted the server ; )

Now everything is working fine, and i am now able to select the devices. The problem was really coming from the packages.

Thanks again for your help,

Best Regards,

Adrien

500
Views
0
Helpful
4
Replies