Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NetConfig job failing with RME_CDL1031

Hi,

I have a NetShow job that is failing with this message:

ERROR:RME_CDL1031:Transport  session to device failed Couldnot enter ENABLE mode from USER mode on Device. Couldnot enter ENABLE mode from USER mode on Device.

I have double checked  the credentials in DCR (manually and using the 'check device credentials' option) and its configured properly.

Could you please advice what is wrong?

Thanks,

Amit

1 REPLY
Cisco Employee

Re: NetConfig job failing with RME_CDL1031

If you are using telnet, the easiest thing to do is get a packet capture of all tcp/23 traffic between the RME server and the device when running the Netshow job.  This will show why RME was unable to enter enable mode.

194
Views
0
Helpful
1
Replies