Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

NetConfig Jobs pause before sending next command

Is there a way to pause sending the second command until the first command completes in a NetConfig Jobs User-defined task? I'm trying to get the following commands to send but  it fails on the second command due to lack of response:

delete /force /recursive flash1:c3750-ipbasek9-mz.122-55.SE1
delete /force /recursive flash2:c3750-ipbasek9-mz.122-55.SE1
delete /force /recursive flash3:c3750-ipbasek9-mz.122-55.SE1
delete /force /recursive flash4:c3750-ipbasek9-mz.122-55.SE1
delete /force /recursive flash5:c3750-ipbasek9-mz.122-55.SE1
delete /force /recursive flash6:c3750-ipbasek9-mz.122-55.SE1


copy tftp://139.78.103.93/IOS/3750/c3750-ipbasek9-mz.122-55.SE5.bin flash1:

copy flash1:/c3750-ipbasek9-mz.122-55.SE5.bin flash2:/c3750-ipbasek9-mz.122-55.SE5.bin

copy flash1:/c3750-ipbasek9-mz.122-55.SE5.bin flash3:/c3750-ipbasek9-mz.122-55.SE5.bin

copy flash1:/c3750-ipbasek9-mz.122-55.SE5.bin flash4:/c3750-ipbasek9-mz.122-55.SE5.bin

copy flash1:/c3750-ipbasek9-mz.122-55.SE5.bin flash5:/c3750-ipbasek9-mz.122-55.SE5.bin

copy flash1:/c3750-ipbasek9-mz.122-55.SE5.bin flash6:/c3750-ipbasek9-mz.122-55.SE5.bin

configure terminal
boot system switch all flash:/c3750-ipbasek9-mz.122-55.SE5.bin

exit
write memory
reload

275
Views
0
Helpful
0
Replies
CreatePlease to create content