We currently have CiscoWorks LMS 2.2 installed and sometimes when a netconfig job is run it just get's stuck in the "Job Started" state for no reason.
Then I restart the Change Audit deamon under Ciscoworks Admin, run the same job again and it completes succesfully.
Sometimes jobs also stops and checking the job details the status appears as "Device was not attempted for update".
The CW Server has:
-RME 3.5 with IDU 13
-CM 3.3 with IDU 11
-DFM 1.2 with IDU 5
The latest patches are applied
This case has been on TAC's hands for 2 weeks.
Also, I would like to know what is the current procedure for applying Microsoft patches to the CiscoWorks server, I mean is it advisable to run Windows Update on the CW server ? Is it recommended by Cisco ?
I would appreciate if anyone can shed a light on this.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...