Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Netconfig - JOBS

when i shedule a job in one of my switch(catos 4006 series) the job fails with the below error

Command(s) failed on the device Could not enter ENABLE Mode from USER Mode on Device. TFTP: Tftp is supported only for config mode commands. Could not detect protocols running on the device Could not synchronize RME archive with Device Config

1 REPLY
Cisco Employee

Re: Netconfig - JOBS

This error indicates a problem with the enable password in DCR for this device. Make sure it is correct. If you are using telnet as a deployment protocol, you can also start a sniffer trace on the LMS server, run the job, then look at the trace to see what credentials are beign used, and what error is being encountered.

110
Views
0
Helpful
1
Replies