Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

NetConfig vs Not attempted in LMS

Hi

I am using LMS 3.2. During changes of configs trough NetConfig very often I am noticed that more than half devices are "Not Attempted" state. I have checked some and I saw that NetConfig properly implemented my changes. But the other hands some didn't adopt.How can I diagnose where is the problem? On server side or device configuration?

Can I debug this information?

I read LMS Help pages and I am not using "Stop on failure" and in previuos use of NetConfig everything was clear.

Best regards

Marek

1 REPLY
New Member

Re: NetConfig vs Not attempted in LMS

I ve found resolutions

devices cannot login to devices cause they haven't got free vty line

183
Views
0
Helpful
1
Replies