We have been looking at the netflow records sent from our devices to our netflow collector and have found a couple of anomolies.
the src and dst mask is often shown as a /32 when this is not actual mask size. Also the output interface is shown as 0 when the packet would have left the device. This is happening on both version 7 netflow from 6500's (catos) and also version 5 from routers. Can anyone explain why this is happening and if it is correct.
If you use mls flow ip full command it will consume more memory in MLS because it will have more entries based on layer 4 information. It is recommended to keep the size of the MLS cache below 32K entries. To keep the size of the MLS cache down, enable mls aging fast. Src-only / Dest-only Microflow policer will not work, when NDE is configured.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.