Community Member

Netflow Catalyst 6500 Sup720

Hi community

I tried to configure netflow without success.

Setup is the following.

Cisco Catalyst 6509 with Sup720-10GE IOS 12.2(33)SHX7. There are around 30 L3 vlans configured on the switch.

I'm only interested for the traffic on one L3 vlan which is the connection to wan cloud.

I wanna see only the traffic that goes to and come from the wan. On other Catalyst where I have routed interfaces i successfully configured netflow.

I read a lot in the forums and documentations but i didn't find the right one.

Any hints or configurations samples?

Regards Markus

Everyone's tags (1)
1 REPLY
Hall of Fame Super Silver

Re: Netflow Catalyst 6500 Sup720

Have you seen either of these two guides below?

1. From cisco.com

2. From manageengine.com

They specifically cover setting up Netflow on a Catalyst 6k.

2728
Views
0
Helpful
1
Replies
CreatePlease to create content