Netflow config on cisco 1712 with a VLAN100 (joining two FE-Ports)
i hope anybody could give a usefuinformation about how i could apply a valid configuration on a cisco 1712 with a VLAN100 (joining two FE-ports, which is connected in two ways for incoming/outgoing traffic, transparently over the VLAN 100 interface ).... i just see only Broadcast (255.255.255.255) but no any TCP-Packets with a valid application port going through from FE1 to FE2 and so on....The only valid TCP-Traffic that i can see is my telnet session (my mgmg PC:192.168.100.173 to the router-itself: 126.96.36.199). I got this setup with a collection station: 192.168.100.4 (called netflow tracker). May be i´m missing any important part in the config setup.
Re: Netflow config on cisco 1712 with a VLAN100 (joining two FE-
would you think the etherchannel configuration would work.. ? I just looked at the technicial specification for the WIC-4ESW that we got here in the cisco 1712 (it does not support etherchannel). May be you look at the setup (attached to this message ) cisco1712-netflow-setup-over-vlan100.gif file.
We are pleased to announce availability of Beta software for 16.6.3. 16.6.3 will be the second rebuild on the 16.6 release train targeted towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are looking for early feedback from custome...