10-27-2005 12:46 PM
Hi,
i hope anybody could give a usefuinformation about how i could apply a valid configuration on a cisco 1712 with a VLAN100 (joining two FE-ports, which is connected in two ways for incoming/outgoing traffic, transparently over the VLAN 100 interface ).... i just see only Broadcast (255.255.255.255) but no any TCP-Packets with a valid application port going through from FE1 to FE2 and so on....The only valid TCP-Traffic that i can see is my telnet session (my mgmg PC:192.168.100.173 to the router-itself: 192.68.100.254). I got this setup with a collection station: 192.168.100.4 (called netflow tracker). May be i´m missing any important part in the config setup.
11-03-2005 03:08 PM
To connect the FE ports they should form an ether channel.
To form a port group follow these steps.
Step 1
configure terminal
Enter global configuration mode.
Step 2
interface interface
Enter interface configuration mode, and enter the port of the first port to be added to the group.
Step 3
port group 1 distribution destination
Assign the port to group 1 with destination-based forwarding.
Step 4
interface interface
Enter the second port to be added to the group.
Step 5
port group 1 distribution destination
Assign the port to group 1 with destination-based forwarding.
Step 6
end
Return to privileged EXEC mode.
Step 7
show running-config
Verify your entries.
11-04-2005 03:55 AM
Hi Pengke11,
would you think the etherchannel configuration would work.. ? I just looked at the technicial specification for the WIC-4ESW that we got here in the cisco 1712 (it does not support etherchannel). May be you look at the setup (attached to this message ) cisco1712-netflow-setup-over-vlan100.gif file.
Best Regards,
cturacci
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide