I've got a serial interface on a 2811 router that has been showing an rx load of 252/255 for about 48 hours.
I've got netflow enabled on it and when I put an ACL on the serial interface to block the offending IP address it does not seem to be working. I've got the log parameter on there and its not showing in the log and the rx load is not decreasing.
Netflow shows it as protocol 27 and the source and destination addresses are not any of the networks configured on this router.
What is going on here? Thanks for any help on this.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...