Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Netflow on 6500 gigabit interfaces

Hi,

I've configured Flexible netflow on my Cisco 6509, Sup2T 10GE w/ CTS, IOS 15.0(1)SY2, and it works fine. However, I can apply 'ip flow monitor FLOW-MONITOR input/output' commands just to L3 VLAN interfaces. These commands are not available for physical interfaces (Gig, TenGig) nor port-channels. Looking at different config guides, examples are shown where these commands are issued on physical interfaces. How come my 6509 doesn't have them? Am I missing something?

3 REPLIES
New Member

Netflow on 6500 gigabit interfaces

I guess "ip flow" is the key to this mystery. Are your gig-ports in switched or routed (no switchport) mode?

New Member

Netflow on 6500 gigabit interfaces

They are switched. 'ip flow...' command doesn't exist on them.

VIP Purple

Re: Netflow on 6500 gigabit interfaces

"ip flow x " commands are only applicalbe for L3 interfaces. So it won't applicable to any L2 switchport like in your case

HTH

Rasika

**** Pls rate all useful responses ****

193
Views
0
Helpful
3
Replies